How to change the Belt on a 12.5” Electric Snow Shovel (Model 56660) Step 1: Remove the 13mm nut from the LEFT end of the motor housing. The nut wil
Step 3: Remove the old belt if needed by pinching on the tensioner. Step 4: Spin the pulley and ease the belt off the edge of the pulley.
Step 5: Loop the new belt around the motor pulley and squeeze the tensioner. Step 6: Attach the belt to the larger pulley. Make sure it is aligned
Step 7: Reinstall the flat washer on the end of the shaft. Step 8: Install the small plastic plate just below the tensioner spring as shown below.
Step 9: Reattach the left cover by installing the plate over the shaft and attach the washer and nut. Then push on the nut to move the cover plate i
Step 10: Tighten the nut on end of the shaft.
Commentaires sur ces manuels